MLS and EIGRP Simulation

Question:
Configure the Multilayer Switch so that PCs from VLAN 2 and VLAN 3 can communicate with the
Server?

mls> enable
mls# configure terminal
mls(config)# int gi0/1
mls(config-if)# no switchport -> not sure

about this command line, but you should use this command if the simulator does not let you assign IP address on Gi0/1 interface.

mls(config-if)# ip address 10.10.10.2 255.255.255.0
mls(config-if)#no shutdown
mls(config-if)# exit
mls(config)# int vlan 2
mls(config-if)# ip address 190.200.250.33 255.255.255.224
mls(config-if)# no shutdown
mls(config-if)# int vlan 3
mls(config-if)# ip address 190.200.250.65 255.255.255.224
mls(config-if)# no shutdown
mls(config-if)# exit
mls(config)# ip routing

(Notice: MLS will not work without this command)

mls(config)# router eigrp 650
mls(configrouter)#network 10.10.10.0 0.0.0.255
mls(config-router)# network 190.200.250.32 0.0.0.31
mls(config-router)# network 190.200.250.64 0.0.0.31

NOTE : THE ROUTER IS CORRECTLY CONFIGURED, so you will not miss within it in the exam , also don't modify/delete any port just do the above configuration.
in order to complete the lab , you should expect the ping to SERVER to succeed from the MLS ,
and from the PCs as well.
If the above configuration does not work, you should configure EIGRP with "no auto-summary"
command : no auto-summary